Dinstar FXS Manual do Utilizador descarregar pdf (Página 25)

DAG Series User Manual

Dinstar Technologies Co., Ltd.

Table 3-3-4 Service Config

RTP start port

Defines the local RTP-RTCP port for listening and transmission.

Silence Suppression

Endpoints sending audio as an RTP stream are not required to send

packets during silent periods. The capability to stop sending RTP

packets during silent periods is known as "Silence Suppression" or

VAD (Voice Activity Detection).

Call Progress Tone

Configure ring or tone frequencies according to preference. By default

tones are set to USA frequencies. Frequencies should be configured

with known values to avoid uncomfortable high pitch sounds.

SLIC Setting

Dependent on standard phone type (and location).

Hook Flash Detect

Time period when the cradle is pressed (Hook Flash) to simulate

FLASH. To prevent unwanted activation of the Flash/Hold and

automatic phone ring-back, adjust this time value.

Preferred Vocoder

The equipment supports up to 4 different vocoder types including

PCMU, PCMA, G.723.1, G.729AB.The user can configure vocoders in

a preference list that will be included with the same preference order in

SDP message. The first vocoder is entered by choosing the appropriate

option in “Choice 0”. The last vocoder is entered by choosing the

appropriate option in “Choice 3”.

FXO Parameter

Many FXO configuration parameters to configure the FXO port

DTMF

Flexible DTMF transmission method, user interface of in-audio,

RFC2833/INBAND/SIGNAL.

SDP parameter when

hold

When the call was hold ,the invitation of SDP the parameters can be

carried inactive or sendonly.

STUN

IP address or port of the STUN server

Incoming display

Caller ID There are two options: the name and number

Polarity Reversal

Default is No. If set to Yes, polarity will be reversed upon call

establishment and termination.

Send Flash Event

Default is NO. If set to yes, flash will be sent as DTMF event

Call Features

Default is Yes. (If Yes, call features using star codes will be supported

locally)

Direct IP-IP Calling

Default is NO

Send Anonymous

Default is No. If this parameter is set to “Yes”, users ID will be sent as

anonymous; essentially block the Caller ID from displaying.

Reject Anonymous Call

Default is NO. If set to yes, incoming calls with anonymous Caller ID

will be rejected with 486 busy message.

No Dial Timeout

Default is 4 seconds

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 40 41

Comentários a estes Manuais

Sem comentários

Dinstar FXS Manual do Utilizador Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Gateways/controladores Dinstar FXS